Quietside QSCC-093 Instruções de Operação descarregar pdf (Página 5)

Step3

Drill Hole for Line Set etc

Remove mounting bracket from the rear of the Indoor unit,

use a Phillips head screwdriver to remove the unit pipe strap, and if

unit is a heat pump the defrost sensor also must be undone from its

retainer. If mounting the unit on an outside wall measure from the

edges of the unit to the center of the line set stub 90° bend to locate the

the center of the wall penetration. Drill a ø 3" hole through the wall

Angle the wall penetration slightly down towards the outside to

assist in draining the condensate away from the unit

If mounting the unit on an inside wall, use the knockouts provided on the LHS and RHS of the unit to route the

piping and wiring connections through

Step 4

Install Mounting Bracket

Locate and secure the mounting bracket to the wall, the Indoor unit

weighs a maximum of 20Lbs, use wall anchors and mount to a wall stud

to ensure that the wall is capable of holding the weight of the unit

Use a level to ensure mounting bracket is leveled, so condensate can

drain properly

Step 5

Prepare Unit Line Set Connections

Rotate refrigerant line stubs set gently through 90° (if mounting on an outside wall), for other line set

configurations align the stubs as required

Tip : Use Duct tape to tape the Condensate hose (make sure it is below the Line set stubs) and the Defrost

Sensor (Heat Pump Only), this makes it easier to guide them though the hole drilled in the wall

Also if possible feed the 14 AWG Interconnect wiring between Indoor and Outdoor (Maximum # of

wires required is 6) through the unit electrical connection (if required by local codes an electrical connector

can be attached to the rear of the unit). Tape the loose wire to the line set stubs.

These two tips save time and prevent damage to the stubs when mounting the Indoor unit

Note :

Condensate hose is taped below line set stubs

Wrap Duct tape to the end of the condensate hose for easier

installation

Installation and Maintenance Manual

Unit Installation (Cont)

1 2 3 4 5 6 7 8 9 10

Sem comentários

Quietside QSCC-093 Instruções de Operação Página 5